Vertical Electric Steam Generator Boiler Installation Simple And Fast Small
Gas-fired steam boiler refers to the steam boiler heated by burning gas. Vertical steam boiler adopts combustion engine setting mode, two-return structure, full fuel combustion, stable operation and less space occupied by the boiler, at the same time, there is a spoiler inserted in the smoke pipe, slow down the smoke exhaust speed, increase heat exchange, high thermal efficiency of the boiler, reduce user cost; Horizontal steam boiler for pot shell type wet back downstream all three return fireworks tube structure, indoor micro positive pressure combustion flame in the combustion, fully extended, low combustion heat load, high combustion efficiency, effectively reduces the exhaust temperature, saving energy and reducing consumption, use a more economic, the waveform furnace and threaded pipe structure, namely improve the boiler heat intensity, and the heat transfer surface heat expansion needs, scientific and reasonable, use for a long time.
1. Fire in the furnace, no open fire outside the furnace, and the steam boiler shall be tested before leaving the factory. After strict testing, the performance of the boiler, combustion equipment, automatic control system and related devices shall be tested; Equipped with high and low water level alarm and low water level furnace shutdown, and automatic control of water pump.
2. Compact structure, single layer layout, less floor space, easy installation.
3. The inlet and outlet are of the same caliber, which can reduce the scaling of furnace bile and increase the service life.
4, the use of glass fiber cotton insulation, small heat loss, high thermal efficiency.
5. Energy saving: Italian burner, low fuel consumption, low noise.
6. Convenience: automatic combustion and water level control, automatic adjustment of air pressure and water level, automatic heating and equipped with water shortage and low-pressure protection of automatic fault detection of the burner.
7. the control system USES traditional electrical components, convenient maintenance.
8. The gas steam boiler is manufactured as a whole and installed as needed.
I. Cleaning and maintenance measures
1. First open the burner door, remove the rear shell panel, and unscrew the rear side cleaning port of the boiler.
2. Clean the gas pipeline with a wire brush.
3. Clean the combustion chamber with a soft brush.
4. For the residue in the boiler, screw the cleaning mouth, close the burner door, and check whether the sealing ring is complete.
5. If the boiler is installed in the area with a temperature below 0℃, take the following protective measures: If the boiler room is outside, reduce the indoor temperature to 15℃ or 18℃, and make the boiler run all day. If no one is in the room for a long time, empty the boiler.
Ⅱ. Boiler sewage treatment.
Boiler bottom blowdown can condense the flue gas. Smoke condensation is due to smoke (diesel or natural gas) in water and smoke temperature is too low, water production. Some of this water is expelled from the chimney, some is absorbed by the chimney walls, and the rest is deposited at the bottom of the chimney.
The amount of water produced is affected by the following factors: the flue gas temperature, which should reach 170℃) the total surface area of the chimney, the material of the chimney and the insulation condition of the chimney.
Ⅲ. Maintenance of burner.
Maintenance of gas steam boiler and burner, maintenance after steam supply. Because the combustion products will corrode the boiler and clean up carbon deposition, so do not let the combustion products in the boiler for too long.