Payment & Shipping Terms:
|Product Name:||PTC Heating Element||Specification:||Custmized|
air heating element,
ptc heating plate
insulated ceramic PTC heating plate liquid aluminum heater heating element
Self-regulating constant temperature ceramic heating plate, which is mainly made of a new type of ceramic thermosensitive synthetic material as a heating element. It uses the change of the resistance value and temperature rise of the heating plate to achieve self-constant temperature heating. As the temperature increases, the resistance value increases. Large, make its current drop to a small current of constant temperature set value, so as to stabilize the temperature and achieve the purpose of self-controlling temperature.
The self-regulating thermostatic ceramic heating plate is not damaged due to its own reasons during normal use. Even repeated switching on and off tens of thousands of times has no effect on its performance, high temperature resistance, no deformation, and long service life.
This product has constant temperature heating, no open flame, high heat conversion rate, minimal influence by power supply voltage, etc. It has advantages that are incomparable with traditional heating elements, and has a higher safety factor.
The self-regulating constant temperature ceramic heating plate has the characteristics of automatic energy saving. When the heater increases the ambient temperature and heating temperature, its power will gradually decrease. Maintaining constant temperature power of 2-4KW (according to the heating area of the ash hopper), the power saving effect is traditional 3-5 times of electric heating element.
The electric heating sheet is evenly distributed on the heating ash hopper, and the distribution points are 5-6 times that of the traditional electric heating wire plate heating. The layout is reasonable, the regional temperature difference is small, and the energy efficiency is high.
If the heating temperature of the ash hopper of the power plant is set to 120 ° C, it only takes 5-10 minutes to reach the target temperature. It is incomparable with traditional heating elements.
Simple and convenient installation:
The heating pads have been grouped in parallel with matching high-temperature wires before leaving the factory, and are equipped with special self-compressing mounting supports. As long as the mounting points are welded to the surface of the ash bucket, the heating pads can be inserted into the mounting base.
This product is mainly used for the electric heating of the ash bucket wall of the electric precipitator in thermal power plants to ensure that the dust in the ash bucket does not dew and ensure the smooth flow of ash. It is also used for heating equipment such as scraper conveyors, ash silos, ash conveyers, conveying chutes, and lime powder silos.
Contact Person: gaoyi